HOT TUB
This amenity guide is our companion for using the hot tub.
1
Unclip the hot tub cover
Undo the two clips on the front of the hot tub’s cover.
2
Lift the hot tub cover
Raise the front half of the hot tub’s cover, fold it over the center bar, and lay it on top of the back half.
3
Raise the metal bar
To the side of the hot tub, at the center of the cover, grab the metal bar then raise it up and backwards so that it’s hanging the hot tub cover behind the back of the hot tub.
4
Start the hot tub
At the front of the hot tub, there’s a control panel. Water jets button “1” starts both water jets on the left side of the hot tub – press it once for low-flow mode, or twice for high-flow mode. Water jets button “2” starts both water jets on the right side of the hot tub – press it once for high-flow mode, and you can press water jets button “1” to run the left-side’s water jets simultaneously. Also, there’s a button for hot tub lights, and buttons to change the water temperature.
5
Let the hot tub turn off automatically
When the hot tub’s water-jets cycle finishes after about 20 minutes, it should turn off automatically.
6
Close the hot tub cover
This will keep the water heated, and prevent debris from getting in. At the back of the hot tub, grab the top of the metal bar then pull it forward and down towards the center of the hot tub. Next, fix the top half of the hot tub cover by lifting it up and unfolding it so that it covers the front half of the hot tub. Place the cover’s front clips back into their mounts to finish up.
