Unclip the hot tub cover

Undo the two clips on the front of the hot tub’s cover.

Lift the hot tub cover by its handle

Grab the handle on the cover, raise the front half of the hot tub’s cover, fold it over the center bar, and lay it on top of the back half.

Please use the handle on the hot tub cover to lift it; if the flap on the hot tub cover is used to lift it, then the cover may rip – damaging the cover.

Raise the metal bar

To the side of the hot tub, by the center of the cover, grab the corner of the metal bar then raise it up and backwards so that it’s hanging the hot tub cover behind the back of the hot tub. Preferably, two people lifting the arms of the metal bar is best – one person at each side.

Start the hot tub

At the front of the hot tub, there’s a control panel. Water jets button “1” starts both water jets on the left side of the hot tub – press it once for low-flow mode, or twice for high-flow mode. Water jets button “2” starts both water jets on the right side of the hot tub – press it once for high-flow mode, and you can press water jets button “1” to run the left-side’s water jets simultaneously. Also, there’s a button for hot tub lights, and buttons to change the water temperature.

When the hot tub’s water-jets cycle finishes after about 20 minutes, the hot tub should turn off automatically.